|
| Processor Type (CPU) Included |
Intel Celeron |
| Number of Processors/CPU Sockets |
Single CPU |
| CPU Socket Type |
Socket 478 (478 pins) |
| Processor Speed |
2.0GHz |
| Maximum CPU Speed |
3.2GHz |
| Processor FSB |
400MHz |
| FSB (CPU Front Side Bus Speed) |
533MHz
800MHz |
| Chipset Manufacturer |
Intel |
| Chipset |
Intel 875P |
|
| System Memory |
Memory Maximum |
4GB |
Memory Sockets |
4 x 184-pin DDR DIMMs | | Memory Features |
- Supports 2.5V DDR400/333 (supports dual channel)
- Supports dual-channel interleaved DDR RAM, using 2 interleaved channels to vastly improve memory clock speed. This results in faster system speed and improved system stability. Note: Dual-channel DDR interleaving requires two DDR RAM modules of identical memory size and speed.
- Supports ECC function
|
| CPU Cache Size (per CPU) |
L2 Cache |
128K |
| Flash Memory Socket(s) |
Type |
DiskOnChip up to 288MB (32-pin DIP) |
|
| Card Form Factor |
Full-length standard card (7.5 to 13.4")
ATX motherboard |
| BIOS |
BIOS Manufacturer |
Award |
BIOS Chip Type |
Flash ROM | | Real-Time Clock (RTC) |
On-board real-time clock (RTC) |
| Special Features |
- Free system assembly and test when a motherboard is purchased with a
CyberResearch chassis, hard drive, and operating system
- OIX 2107 benchtop keyboard included free upon request when you purchase a complete system with your motherboard
- RTC/CMOS Built in ICH5R
- Please note that this motherboard does not support Win98/XNT
|
|
| Slot Quantity of Typical Chassis |
8 slots |
| Expansion Slots (max. number of cards) |
7 slots |
| Max. Number of PCI Cards |
4 |
| Max. Number of ISA Cards |
2 |
| PCI Slots |
Number of PCI Slots |
4 PCI slots |
Type of PCI Slot(s) |
32-bit 5V standard (notch farthest from backplate) | | ISA Expansion Slots |
2 ISA slots |
| AGP Slot Type |
1 AGP slot |
| Slot Special Features |
While most ISA boards are likely to work in these models, 100% compatibility
with all extant ISA boards cannot be guaranteed. 100% satisfaction guaranteed --
we will work with you to find a solution for your application (call for details) |
|
| Video RAM |
2MB |
| Video Channels |
1 x analog VGA |
| Video Chipset |
SMI 712 |
| Video Output Signals |
Analog |
Analog VGA (standard for CRT or flat-panel) |
| Video Bus Type |
AGP 8x |
| Video Output Connectors |
HD15 (standard VGA) connector |
|
| I/O Controller |
Winbond W83627HF |
| On-Board LAN |
Ethernet Controller Type |
Intel 82547GI 10/100/1000Base-TX (Gigabit) |
Ethernet |
Channels |
1 x Gigabit (10/100/1000Base-T) | Connector(s) |
1 x RJ-45
2 LEDs indicate LAN access and link status | Wake-on-LAN |
Yes | | Serial Ports |
Serial (COM) Ports: RS-232 |
Number of RS-232 Serial Ports |
3 |
RS-232 Signals Supported |
TXD (TD, TX) Transmitted Data
RXD (RD, RX) Received Data
RTS : Request to Send
CTS : Clear to Send
DCD (CD) Data Carrier Detect
DSR : Data Set Ready
DTR : Data Terminal Ready
RI : Ring Indicator
GND : Signal Ground | Communications Protocol |
Asynchronous (async) | Serial (COM) Ports: RS-422/485 |
Number of RS-422/485 Serial Ports |
1 | Serial Port Mode Select |
Jumper-selectable | Serial (COM) Ports: RS-232/422/485 |
Number of RS-232/422/485 Serial Ports |
1 | Serial Port Mode Select |
Jumper-selectable | RS-232 Signals Supported |
TXD (TD, TX) Transmitted Data
RXD (RD, RX) Received Data
RTS : Request to Send
CTS : Clear to Send
DCD (CD) Data Carrier Detect
DSR : Data Set Ready
DTR : Data Terminal Ready
RI : Ring Indicator
GND : Signal Ground | Serial Port Connectors |
One DB-9 RS-232 port on I/O backplate, two RS-232 headers and one RS-232/422/485 header on board | | USB Ports |
USB Ports, Total Qty. |
8 |
USB 2.0 Ports (480Mbps) |
8 | USB Connectors |
6 standard female USB sockets (Type A / rectangular)
Header on card for 2 USB ports | | Parallel Ports |
Parallel Ports, Total Qty. |
1 |
Parallel Port Modes Supported |
ECP (Extended Capability Port, bidirectional)
EPP (Enhanced Parallel Port, bidirectional)
SPP (Standard Parallel Port) | Connector Type |
Standard DB-25 female (IEEE-1284 Type A) | | Floppy Drive Ports |
Number of Drives Supported |
1 FDD port - supports up to 2 floppy drives |
Connector Type |
34-pin male header | | EIDE (hard drive) Ports |
Number of Drives/Devices Supported |
Up to 4 hard drives / devices |
EIDE Interface Type |
Ultra ATA/100 (ATA/100, ATA-6) 100MB/sec | Connector(s) |
2 x 40-pin male headers | | SATA (hard drive) Ports |
Number of Drives/Devices Supported |
Up to 2 SATA drives |
SATA Interface Type |
SATA 1.5Gb/s (SATA/150, Serial ATA) | Connector(s) |
2 x 7-pin SATA (male) | | IrDA (infrared) Port |
IrDA Connector |
Header for IrDA (infrared) port |
| Digital I/O |
Number of I/O Lines |
8 |
Configuration |
4 inputs
4 outputs | Features |
12-pin digital I/O header connector supports TTL levels | |
| Keyboard Connector(s) |
1xPS/2 (6-pin mini-DIN female) |
| USB Keyboard Supported |
Yes |
| Pointing Device Connector |
PS/2 (6-pin mini-DIN female) |
| External Power Input Connector |
20-pin ATX male connector
4-pin auxiliary 12V connector |
| ATX Power Control Connector |
2-pin header for ATX power control |
| Chassis Controls Header |
Header for reset switch
Header for ATX power switch
Header for power indicator LED
Header for hard drive activity LED |
| Fan Connectors |
Standard 3-pin male fan connector |
| Chassis Intrusion Header |
2-pin chassis intrusion header |
|
| Audio Support (on-board) |
5+1 surround sound output |
| Audio Codec Supported |
AC'97 |
|
| ACPI/APM Function |
Soft Off
Wake On LAN (WOL)
Wake On Keyboard
Wake On Ring (on modem/serial ring detect)
Wake On RTC Alarm (at a set date & time)
Intruder Detect Input
Suspend to RAM (STR, Standby)
Wake On PCI (allows wake up from a PCI card) |
| Temperature |
3 channels |
| CPU Thermal Alarm |
Audible alarm if CPU exceeds a user-specified temperature
System will shut down if CPU exceeds a user-specified temperature |
| Fan(s) |
3 channels |
| Watchdog Timer |
Yes |
| Watchdog Time-Out Intervals |
1 to 255 seconds in 1-second intervals |
|
| Power Consumption, typ. |
- 2GHz/400 P4 with 512MB DDR RAM: +5V @ 0.47A, +12V @ 9.34A
- 2.4GHz/533 P4 with 512MB DDR RAM: +5V @ 0.65A, +12V @ 5.94A
|
| +5VDC |
650mA |
| +12VDC |
9.34A |
|
| Fan for Processor (CPU Fan) |
1 included |
|
| Operating Temperature |
32°F....140°F
(0°C....60°C)
|
| Storage Temperature |
-4°F....176°F
(-20°C....80°C)
|
| Relative Humidity, noncondensing |
10%....90% |
|
| Safety/Approvals |
Meets RoHS standards |
| Power Management |
ACPI (Advanced Configuration and Power Interface) |
|
| Width |
12.01"
(305mm)
|
| Depth (front-to-rear) |
9.59"
(243.7mm)
|
| Height (w/o CPU or RAM) |
1.67"
(42.44mm)
|