UMDAS TCLOG - Remote Thermocouple Input Logger - 8 Thermocouple Channels, Alarm Functions, with USB Power Adapter, Cable, and 64MB CompactFlash Card

Home

Engineering Software & Communications

USB & Serial Products

USB

USB Data Acquisition Modules

Screw Terminals, CompactFlash Socket, CJC Sensors, USB 2.0 Port, and Activity LED for Direct Temperature Measurement

UMDAS TCLOG
Remote Thermocouple Input Logger - 8 Thermocouple Channels, Alarm Functions, with USB Power Adapter, Cable, and 64MB CompactFlash Card
Qty	Price (with options selected)
Shipping: 1-2 weeks

Features

	System Bus		USB 2.0
	Number of Channels		8
	A/D Converter Resolution		24-bit
	Max. A/D Speed (throughput)		24Hz
	Number of I/O Lines		8

Introduction

If your remote facilities are not convenient to your host PC, we recommend the datalogger versions of our UMDAS TC and UMDAS TH USB data acquisition modules. In the UMDAS TCLOG and the UMDAS THLOG, the microprocessor stores your temperature data on the included 64MB CompactFlash card (upgradeable to 2GB maximum). You can retrieve your data by swapping out the CompactFlash card, or you can download data to a portable PC.

Since there is not usually a PC linked to the dataloggers, they come with firmware that allows you to use each of the eight DIO channels to trigger local alarms when temperatures stray above, below, or outside your defined set-points or ranges. If there is a nearby PC, connect the USB cable and use the dataloggers just like the UMDAS TC and TH modules.

Choose from our family of USB temperature-input devices:

UMDAS TC: USB bus, 8-ch thermocouple input, CJC, 8 DIO
UMDAs TCLOG: UMDAS TC with 64MB CompactFlash (no PC required)
UMDAS TH: USB bus, 8-ch thermocouple, RTD, thermistor, or semiconductor input, CJC, 8 DIO
UMDAS THLOG: UMDAS TH with 64MB CompactFlash (no PC required)
UWDAS TC: Wireless and USB bus, 8-ch thermocouple input, CJC, 8 DIO
UWDAS TH: Wireless and USB bus, 8-ch thermocouple, RTD, thermistor, or semiconductor input, CJC, 8 DIO
UWDAS TXM: USB interface module for support of up to 10 UWDAS modules

			Less Detail

Product Information
System Bus			USB 2.0
Bus Information	Baud Rate, Max.		24 bps
	Bus Standards Compliance		USB 1.1 USB 2.0
	System Bus Details		USB Connector: Type B (4-pin, square) female USB +5V Input Voltage: 4.75V to 5.25V
Mounting Configuration			Desktop / benchtop External module
Direct Sensor Input			Thermocouple
On-board Microprocessor			Yes
On-Board Memory for Processor			1.5k
Analog Input Channels
Number of Channels			8
Differential Channels			8
A/D Converter Resolution			24-bit
Max. A/D Speed (throughput)			24Hz
Typ. A/D Speed (throughput)			24Hz
A/D Speed/Bandwidth Details			Logging requires a minimum of 1 second between 24-bit temperature readings. Maximum interval between readings is 2 exp 32 seconds.
Cold Junction Compensation			CJC on all channels
Accuracy	Relative Accuracy		Maximum error depends on thermocouple type used and on temperature range. Maximum error for all types and all ranges is +/-1.969 deg. C.
	Nonlinearity		On-board microprocessor automatically linearizes all data using the appropriate NIST linearization coefficients.
Noise	CMRR (Common Mode Rejection Ratio)		100 dB min.
	NMRR (Normal Mode Rejection Ratio)		90 dB min.
Input Impedance			5000MΩ
Input Impedance Details			5 Gohm, min.
Input Protection			Protected against voltages to +/-25VDC, max. (power on), +/-40VDC (power off)
A/D Special Features			Max. Logging Rate/Channel: 2 Sample/s to PC, 1 Sample/s to CF card CJC sensors on both sides of the module
Input Ranges
Bipolar Input Ranges			-80mV to +80mV
Thermocouple Support	Thermocouple Inputs		J-type thermocouple K-type thermocouple T-type thermocouple E-type thermocouple R-type thermocouple S-type thermocouple B-type thermocouple N-type thermocouple
	J-type Range Supported		-346°F....2192°F (-210°C....1200°C)
	K-type Range Supported		-346°F....2501.6°F (-210°C....1372°C)
	T-type Range Supported		-328°F....1112°F (-200°C....600°C)
	E-type Range Supported		-328°F....1832°F (-200°C....1000°C)
	R-type Range Supported		-58°F....3214.58°F (-50°C....1768.1°C)
	S-type Range Supported		-58°F....3214.58°F (-50°C....1768.1°C)
	B-type Range Supported		482°F....3308°F (250°C....1820°C)
	N-type Range Supported		-328°F....2372°F (-200°C....1300°C)
A/D Range Selection			Fixed
Input Range Details			Channel configuration is stored on the EEPROM of the isolated microprocessor.
Gains			1
Isolation, Field-to-Logic			500VDC
Trigger Modes
Triggering Type(s) Supported			Software trigger (software-controlled trigger)
Digital I/O
Number of I/O Lines			8
Primary Digital I/O	Configuration		8 bidirectional
	Input/Output Selection		Software
	Signal Connector		Screw terminals.
	Inputs	Input Voltage - High (Vih, DC)	2V....5.5V
		Input Voltage - Low (Vil)	-0.5V....0.8V
		Digital Input Features	50 port reads or single-bit reads per second, typical.
	Outputs	Output Voltage - High (Voh)	3.8V....5V
		Output Voltage - Low (Vol)	0mV....0.7V
		Output/Relay Details	100 output port writes or single-bit writes per second, typical.
Software
Software Included Free with Product			Software developer's kit calibration software
Software Included - Features			Drivers and libraries
Operating System Compatibility			Windows XP Windows 2000 Windows Me Windows 98SE
Software Compatibility			Universal Driver Library DASYLab® LabVIEW®
Cables and Connectors
Connector #1	Quantity		52
	Type		Screw terminals
	Location		On module
Connector #2	Quantity		1
	Type		USB Type B (4-pin, square)
	Gender		Female (socket)
	Location		On module
Connector & Cabling Details			Includes 3-foot USB Type A to Type B cable Screw Terminal Wire Gauge Range: 16 AWG to 30 AWG
Construction
Construction Material			Impact resistant ABS plastic
Protection Rating			NEMA 1
Power
Power Consumption (typical)			Consumes 500mA max. from USB cable. Included AC Adapter power supply required for datalogging.
Power Supply Notes			Included AC Power Adapter (for data logging): Output Voltage: 5V, ±5% Output Power: 2.5W Input Voltage: 100 to 240VAC, 50 to 60Hz Input Current: 0.2A
Indicators & Controls
Other Control Features			Push button on side to initiate data logging Temperature alarms Activity LED
Display			LED show status of signal
Environmental Specifications
Operating Temperature			32°F....158°F (0°C....70°C)
Storage Temperature			-40°F....185°F (-40°C....85°C)
Relative Humidity, noncondensing			0%....90%
Dimensions
Width			3.45" (87.7mm)
Height			1.5" (38.17mm)
Depth			5.1" (129.52mm)
Weight
Weight			0.4lbs (181.44g )
Shipping Weight			1.8lbs (816.46g )

Less Detail

Ordering - Includes Options Indicated Below

UMDAS TCLOG
Remote Thermocouple Input Logger - 8 Thermocouple Channels, Alarm Functions, with USB Power Adapter, Cable, and 64MB CompactFlash Card

$595.00

Cable Options
	None
		CBL USA16 USB Repeater Cable, USB 2.0, USB A M to USB A F Connectors, 16 ft	$29.00
		CBL USBETH USB to Ethernet Converter Cable, USB 2.0, USB A Male to RJ-45 Female Connectors, 3 ft	$39.00

Accessories
	None
		CFM 0512 512MB CompactFlash Card - Type I	$60.00

Catalog #	Shipping	Price (with options)	Qty
UMDAS TCLOG	1-2 weeks

Customers Were Also Interested In These

Did you find this page useful?

Toll-Free Hotline 1-800-341-2525 • Tel: 203-483-8815 • Fax: 203-483-9024